How do I run a full system scan and check the results in GetOverX Shield? - Printable Version +- GETOVERX FORUM Community Support (https://forum.getoverx.com) +-- Forum: getoverx Shield (https://forum.getoverx.com/forumdisplay.php?fid=1) +--- Forum: Antivirus (https://forum.getoverx.com/forumdisplay.php?fid=2) +--- Thread: How do I run a full system scan and check the results in GetOverX Shield? (/showthread.php?tid=85)

How do I run a full system scan and check the results in GetOverX Shield? - AdrianGomez - 12-05-2025 I just installed GetOverX Shield and I’d like to run a full system scan. How do I start it, and where can I review the logs and actions after the scan finishes? RE: How do I run a full system scan and check the results in GetOverX Shield? - mrwebfeeder - 12-05-2025 Hi and welcome ? To run a full system scan in GetOverX Shield: Open the Antivirus section. Choose the Scan Mode that allows you to either: Select specific paths, or Run a full system scan that goes through your main drives. Start the scan and wait for it to complete. Progress and detections will be shown in the scan panel. When the scan is done: Logs and actions can be reviewed directly from the Scan panel in the Antivirus module. You’ll be able to see which files were scanned, what was detected and what action was taken (clean, quarantine, delete, etc.) If you need help interpreting a specific detection, feel free to copy the detection name and ask here in the forum.